Parts For Kiln: HT14D

Name

Description

Quantity

Price

1332 Gas Inlet Flow Meter

KIT 1/4" GAS INLET AND FLOW METER (MANUAL) During heat treating, scale forms on the surface of the steel. One way to eliminate most scaling is to wrap the steel in stainless steel foil. An easier way is to install the gas injection flow meter on your

$200.00

CR14

CORDSET, 20 AMP, 240 VOLT, NEMA 6-20, 6 FOOT

$31.00

TF62

RS232 PORT ON SENTRY II CONTROLLERS (PC CONTROL) The RS232 is a computer port mounted to the kiln. You can monitor the kiln from a computer and store a record of each firing on your hard drive. Print graphs of firings.

$360.00

Firing Safety Glasses

Wear firing safety glasses whenever looking into the firing chamber of a hot kiln. Filters the infra-red and ultra-violet light. Reduces glare, makes pyrometric cones easier to see.

$19.50

ST8 Kiln Stand

The heavy-duty ST8 stand raises your kiln to a convenient 28" height. Begin operating your new kiln without having to find a table strong enough to support it. The table is 147 pounds of rock-solid construction. Ships fully assembled. 30 1/4" square

$380.00

TF2

TRANSFORMER 120/208/240V(UNIVERSAL)

$30.00

TF3

RELAY 30 AMP, 12 VOLT COIL

$30.00

ELHT14

ELEMENT HT14, 240 VOLTS, 9.25 OHMS, 2 PER KILN

The element comes pre-stretched for a precise fit. Element connectors are included with each new element.

$41.00

Knifemakers Heat Treating Kit

Contains 1 pair hot gloves, 1 heat treating fork, 4 knifeholders, and 8 firebrick supports.

Hot Gloves

For intermittent handling of hot objects up to 400° F. Sold in pairs. Not intended for handling hot blades.

Heat Treatin

$64.00

PY50

THERMOCOUPLE FOR 3" WALLS, 18" thermocouple lead wire. Note: If your kiln requires a longer thermocouple lead wire than 18", specify wire length and kiln model.

$53.00

TF41

CONTROL BOARD, SENTRY II, 2000 DEGREES F (MAX TEMP)

$385.00