Kiln Support
  
Paragon HomeKiln ProductsWhere To Buy KilnsKiln SupportAbout ParagonKiln Resellers and Dealers
Search Menu

FAQ/Answer

I get an FTC message on my Sentry controller when I use a slow cooling rate.

Most digital controllers can slow down the cooling rate. But if you program a cooling rate that is faster than the kiln's natural ability to cool, you may get an error message. For instance, Paragon's Sentry 2.0 will flash FTC (Failed to Cool) if the programmed cooling rate is too fast. To avoid that error message, estimate your kiln's natural cooling rate:

During a typical firing, write down the temperature and time that your kiln fired to maturity. Let the kiln cool naturally. Every two hours, write down the temperature shown on the digital controller. If you have a switch-operated kiln, you will need a pyrometer to read the temperature.

To figure cooling rate, subtract a temperature from the one that came two hours before. Then divide by two hours. That is the hourly rate.

Example:

The kiln shuts off at 2200°F.

After two hours, the temperature falls to 1800°F.

2200 minus 1800 equals 400

400 divided by 2 hours equals 200

In this example, the cooling rate is 200° per hour. The cooling rate may get slower the closer the kiln gets to room temperature.

To avoid the FTC (Failed to Cool) message, program a slow cooling segment at a slower rate than your kiln's natural cooling rate.



Paragon Kilns on FacebookParagon Kilns on Twitter Paragon Kilns on YouTube Paragon RSS Feed

Kilns Sold

Get The Adobe Reader

Home

  • Home
  • Privacy Statement
  • Legal Notice
  • Paragon's Green Statement
  • Where To Buy Kilns
  • Resellers
  • About Us
  • Contact Paragon
  • News & Events
  • Support

  • Kiln Technicians
  • Kiln Support
  • Products

  • Bead Kiln
  • Glass Blower's Crucible Furnace
  • Ceramic Kilns
  • China Painting Kilns
  • Enameling Kilns
  • Industrial Furnaces
  • Glass Kilns
  • Lamp Working Kilns
  • Pottery/Ceramic and Glass
  • Pottery Kilns
  • Silver Clay Kilns
  • Wax Burnout Furnaces
  • Heat Treating Furnaces
  • Knife Making Furnaces
  • Custom Furnaces
  • Discontinued Models
  • “Custom and standard Kilns and Industrial Furnaces for ceramics, pottery, heat treating, enameling,
    dentistry, laboratory, and glass fusing.
    Better Designed Kilns from Paragon Industries!"